Posts

Principle of As-300 Hall Flowmeter

-
    Principle of As-300 Hall Flowmeter Hall Flow Rate of 50 g metal powders AS-300 Hall Flowmeter Funnel determines flow rate by measuring the time taken by 50 gram of a metal powder to flow through a calibrated hall flowmeter funnel/orifice of standardized dimensions(0.1 inch/2.5 mm) according to International Standards. Apparent Density of free-flowing powders AS-300 Hall Flowmeter determines the apparent density by permitting a volume or certain quantity of powder in a loose condition to flow from a hall flowmeter funnel orifice Diameter 0.1 inch/2.5 mm into a specified density cup of definite volume(25 cm³) under controlled conditions.  The mass of powder per unit volume (the ratio between the mass and the volume) is recorded and reported as apparent density. Apparent Density of non-free-flowing powders AS-300 Hall Flowmeter determines the apparent density by permitting a volume or certain quantity of powder in a loose condition to f...
Post a Comment
Read more

Machining process information

-
                                                         Machining Introduction :- machining is the most important of the manufacturing processes. Machining can be defined as the process of removing material from a workpiece in the form of chips. The term metal cutting is used when the material is metallic. Most machining has very low set-up cost compared to forming, molding, and casting processes. However, machining is much more expensive for high volumes. Machining is necessary where tight tolerances on dimensions and finishes are required.                  Different Types of Machining Operations :- Three primary machining processes — turning, drilling, and milling — are used as a means of removal. Each process plays a key role in how a product is manufactured and enhances each product’s uniqu...
1 comment
Read more